Eco-Ondol · Electric underfloor heating from Korea

Rod-type electric underfloor heating

Electric underfloor heating from South Korea. Heating element: SUS 304 steel tube, 11 mm in diameter, with magnesium oxide and a heating coil inside, no liquid. Rods come in 8 lengths, from 1 to 4 m, and connect in parallel to a common cable through T-couplings. Protection rating IP68. The rods are laid under a screed, on guide panels for dry installation or in a gravel layer. Used in residential and public buildings, saunas, schools, kindergartens and hospitals.

Prices on request. We prepare a quote for your volume and delivery country.

Specifications

Country of manufacture
South Korea
Rod lengths
1.0; 1.5; 2.0; 2.5; 2.8; 3.0; 3.5 and 4.0 m, codes from MECO-10 to MECO-40. U-, S- and W-shaped rods are made to order
Model 600, rod power
55, 82, 109, 136, 153, 164, 191 and 218 W for lengths from 1.0 to 4.0 m. Per 3.3 m² of floor: initial power 600 W, average 180–200 W. According to the manual, model 600 is for indoor use only
Models 450 and 850, rod power
450: 41, 61, 82, 102, 115, 123, 143 and 163 W. 850: 73, 109, 145, 182, 204, 218, 255 and 290 W. Same lengths, from 1.0 to 4.0 m
Voltage
220 V, 60 Hz according to the model 600 manual, current per rod from 0.25 to 1.0 A. The annex to the CE certificate for model 600 states 240 V~, 60 Hz
Rod
Ø11 mm tube made of SUS 304 stainless steel (POSCO steel). Magnesium oxide and a heating coil inside, no liquid. The 2 cm of rod next to the coupling does not heat. Double-insulated power wire
Protection
IP68. KTC test report (Korea) of 14.11.2017, model ECO-10
Installation
The rods are laid out at a 250 mm spacing and the wires are connected, with 4 cm of mortar on top. No more than 6 kW per circuit; ground-fault protection is required. Base: aerated concrete, unreinforced concrete, cement boards, guide panels for dry installation, or gravel for heat storage
Scope of delivery
Rods, power cable, connecting sleeves, heat-shrink tubes, insulating caps, U-pins and grounding parts. The thermostat is not included; the installer buys it
Layout design
A rod layout design based on the room plan is required before ordering according to the factory

Logistics

Minimum order
None. The factory recommends a full container. You can start with a few trial orders to see which lengths sell, then order larger volumes according to the factory

Documents

Document Issued to Valid until
CE: certificate of conformity under LVD directive 2014/35/EU No. 4788472493, product “Heating pipe”, models from 600-10 to 600-40 (Ø11 mm, length from 1000 to 4000 mm, 240 V~, 60 Hz, from 55 to 220 W), EN 60519-2:2006 and EN 60519-1:2015, issued by UL Korea on 10.07.2018 factory validity not stated in the certificate
UL (USL, CNL: USA and Canada), certificate No. 20180731-E494996 of 31.07.2018, Eco-Ondol 450 series, lengths from -10 to -40, floor heating under the floor covering. The standard number in the image is small and illegible factory validity not stated, issued 31.07.2018
IP68: KTC test report (Korea), model ECO-10 factory report of 14.11.2017, no validity period

Request a price and quote

Prices on request. We prepare a quote for your volume and delivery country.

Requests are handled by the marketplace team in Almaty. We reply in English or Russian.

Add country, volume or a question

Other products

All 6 products: Electric underfloor heating from Korea

We will request the full catalog from the factory and send it to you. Leave your phone or email in the form at the bottom of the page.

Close